Do you need to cut a concrete floor near a wall? This can be an extremely awkward proposition. Please read below for some tips on how to do this properly.
Cutting concrete floors is straightforward if you get the safety precautions right and understand how to do it.
However, floors are different, and, in some cases, the fixtures close to them make the job challenging for you.
One typical example is where you need to cut concrete floors in tight corners and places near the walls. Here is where you will be required to dig deep and find out the best ways to make the cuts.
Doing it is not all doom and gloom, and with a few tips, you can make light work of these awkward situations.
Find the Best Saw
Many saws are designed to cut flat surfaces, and their bulky bodies make it hard to access corner spaces such as the intersection of floors and walls.
However, a few saws have been designed in such a way that makes them suitable for such scenarios.
If you are taking on a project that will involve cutting concrete in tight places, it is better to find a saw that is suited for that.
An example is a toe kick saw that consists of a little blade attached to a regular round saw with a lengthy joint. The name toe kick refers to the space beneath kitchen base cabinets.
The long joint holding the blade allows it to access such tight spaces and make cuts.
Undercut saws are a great option and operate differently from the toe kick ones. They are mounted to the saw’s motor with its position being perpendicular to the body of the saw.
The positioning of this saw allows you to place the toll against the surface, saw the wall and cut through the tight space.
Other notable saws suited for such applications are handheld rotary tools and masonry wall saws.
Find the Best Blades
You are limited to a few options when making concrete cuts in tight places. Therefore, you need to choose your blade wisely. Using the wrong blade will make it difficult to cut the area correctly.
The disadvantage of these tight spots is that once you make a wrong cut, it becomes difficult to correct the mistake.
Diamond blades are singled out as the top options for making cuts across a wide variety of scenarios, and it is best if you use them when cutting near a wall.
Ensure that you buy the right blade for this application.
Observe Safety
When faced with a challenging situation such as cutting concrete in tight spaces, it is easy to focus on handling the task correctly and forget about safety.
Safety should be a priority regardless of the concrete cutting application you are engaged in. Remember to watch the dust and always wear a safety mask when cutting concrete.
Ensure that as you maneuver and position your body to make the right cut, you stay grounded and don’t lose your balance.
Most concrete cutting accidents are due to the operator not being properly balanced. Keep your body away from the saws rotation route to avoid any potential injuries.
Once you have made the cut or if you are taking a break to pick up a call or do anything else, make sure you deactivate the saw. Make sure you unplug it from the wall and totally disengage it.
Leaving it engaged poses a considerable risk to you and the people around the site.
Some of the ways to cut concrete in tight corners have been mentioned above. It can be concluded that making such cuts is reasonably easy if you have machines that are designed to make them.
With the proper technique and with the right tools, you should be able to make these cuts safely.
If you are looking for a specialist concrete cutting company who uses only the best practices to get the job done right, then please call us at Megasaw on 1300 920 419 or contact us through our website.